Battery compartment :- It's made up from a baby formula bottle cut to fit in the gap and panel pinned and glued, the front circle is 3/4 mdf, the back circle is plastic 2 inch circle, screwed and glued, then bondo'd to form that cone to the back of the gun, Front vent and rear:- At the front I used 1/4 ply, pinned to the chamber and glued, then used whatever would make the recess on the inside sit right with me, I started to free wheel here to be honest, I like plans but at the same time I want to make my gun by me for me, so if I'm a little loose it's because I may not have measured and eye balled it or played it by ear to see what worked, after all this is my first weapon build so I was figuring it out as I went, I used the foam to cut out the vents on the front and back and just superglued them in, the placement was marked out, but the vents I made up to fit as I went.

Tools:- ( I'm not normally that messy in the pic, this was mid build! ) Saw Bandsaw Dremel tool Drills G clamps Sander ( orbital, belt, or just paper) Brushes ( small to 2 inch) Screwdrivers And again, anything I've forgot I'll explain on the way, but I think that's most stuff, I don't have a massive setup so I do with what I have, right on with the build! The tools and bits list is a big one, and chances are I'm probably gonna miss a bunch of stuff, because like the fallout helmet, I used what I could get my hands on and modified house hold items to try get the lazer look ! Materials:- Research pictures Off cuts of wood, mdf (3/4 inch) (1/4 inch) Off cut plastic Plastic tub Threaded rod, ( 6 mm rod, about 2ft) 2mm foam board Various paints, black, silver, olive drab, yellow, browns and clear coat spray paint Bits and bobs ( loose nuts, bottle nossel screws, masking tape, plumbing parts small, glue, wood glue or pva, superglue, and other bits, if I've forgot anything I'll explain on the way.

Laser rifle new vegas